Oops, I've been home for a week! And in that week, I decided to do some crafting and thus making my living room and craft room a mess... again! I really should learn how to pick up after myself ;) Anyway, last summer, I made a navy blue t-shirt skirt and I absolutely love it! I bought a really cute button up t shirt while in Denver that matches perfectly. However, I did not have any sandals to wear that match... and I spent all my spending money while in Denver :) Pinterest to the rescue! I found a blog that shows how to make your own sandals from flip flops that hurt your feet, so I tried it! And I LOVE them!
Pictures and a how to?! Sure, why not :) In fact, I'll do two in one post, first I'll link you to the blog for the skirt - I don't have the pictures along the way, so I'll let the original blogger show you :)
The Skirt (The picture is of mine)
This is the blog that I found the tutorial on: http://sewlikemymom.com/the-shirt-skirt/
On to my shoes!!!
I found the idea on pinterest, thanks to this blog: http://annekata.com/2010/07/make-your-own-summer-sandals/
Here is the step by step, how I did it :) I used hot glue, only because that was all I had. When I get waterproof stronger glue, I will reinforce them. They did hold up during my night out though!
This is the original pair of flip flops. I LOVED them, but the plastic straps rubbed on my pinky toe and *always* gave me blisters. I tried my hardest to wear them year after year, hoping that my skin would harden and not blister and every year, I'd get big blisters!
I started by cutting off the plastic strips down at the base.
This is what they looked like after I cut the straps off.
Using the left over t-shirt from my skirt, I cut 4 wide strips for the straps (2 for each shoe) and then 4 long skinny strips to be used for the ankle straps.
I measured 1 1/2 in long lines in the base of the shoe. 2 on each side. These are where the wide straps will be placed.
The arrows point to the two lines on one side.
I took a utility knife (you could use a craft knife) and slit open where I drew the lines.
I put hot glue in the strip first (not shown), and then I pushed one edge of the wide strip into the slit with the corner of my ruler. After I shoved the fabric in, I added more glue on top of the fabric and then on the bottom.
I repeated the last step 3 more times for each shoe. I crossed the straps to create an 'x' (much like how the plastic used to be).
This is the top view after both were done.
These are the ankle straps. I pulled the strips of fabric tight, so they curled up and stretched out. I tied two together to create one ankle strap. In the end, I made two long straps from 4 short ones.
Underneath the heal, I glued the knot to the shoe.
The strap comes up and ties around the ankle. When I tried the shoes on, the wide straps in the front had stretched and were way too loose. My feet kept sliding out of them. It took me a good hour of trial and error to figure out how to tighten the straps without pulling them out and re-glueing them. I forgot to take pictures of the trial and error part, however I did get a picture of the final outcome :)
Again, this is the final!
You can see, I took the original flowers and added them to these. I finally tightened the straps by pulling them in at the 'x' and safety pinning them. Then I cut out two more thin strips and pulled them tight. I looped those around the pins and tied them into the original ankle strap. The flower was the perfect cover up for the ugly fix :) And because they were made from the same t-shirt that my skirt was, they match perfectly!!!